Full Product Manual

4
Safety
This manual should be read and well understood before the instrument is used.
• Never attempt to repair or modify your instrument. Dismantling your
product, other than for the purpose of replacing batteries, may cause
damage that will not be covered under the manufacturer's warranty.
Servicing should only be provided by an authorized service center.
• Do not operate in an explosive atmosphere.
• Do not operate in the presence of ammable gases or fumes.
• Keep away from live circuits.
• Do not remove the instrument cover.
• This meter is for indoor use, altitude up to 2000m.
• When measuring in-circuit components, rst de-energize the circuits
before connecting the test leads.
• Do not measure a capacitor that is not fully discharged.
•
When measuring within a circuit, the circuit must be de-energized before
connecting the test leads.
• Wipe the instrument clean when used in a dusty environment.
•
Do not leave the instrument exposed to direct heat for long periods of time.
• Before removing the battery cover, ensure that the instrument is
disconnected from any circuit and is powered OFF.
Features
• Measures inductance, capacitance and resistance
• Autoranging for AC impedance and DE resistance measurement
• Auto LCR smart check and measurement
• Series/Parallel modes
• Ls/Lp/Cp with D/Q/Ø/ESR parameters
• Support DCR mode 200Ω to 200MΩ
• High accuracy with 4/5 terminal Kelvin measurement
• 10kHz testing frequency and up to 100kHz output frequency
• Large backlit dual LCD display
• Data hold and relative functions
• Low battery indication with auto power off
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com