Full Product Manual

Data Logging ....................................................................................... 15-17
Data Recording Modes ...................................................................... 15
Manual Data Logging Mode ............................................................... 15
Automatic Data Logging Mode .......................................................... 16
Transferring Data from the SD Memory Card to a Computer ........ 16-17
Calibration ......................................................................................... 17
Clearing Conductivity Calibration Data ............................................. 18
Data Stream Output ............................................................................18-19
3.5mm Terminal to RS-232 Serial Connection ................................... 19
System Reset ........................................................................................... 19
Battery Replacement ............................................................................... 19
Applications ............................................................................................. 20
Accessories and Replacement Parts ....................................................... 20
Frequently Asked Questions (FAQ's) ....................................................... 21
Product Care ............................................................................................ 21
Product Warranty ..................................................................................... 22
Product Disposal and Recycling .............................................................. 22
Product Support ...................................................................................... 22
Introduction
Thank you for purchasing your REED R3100SD Data Logging
Conductivity/TDS/Salt Meter. Please read the following instructions
carefully before using your instrument. By following the steps outlined in
this manual your meter will provide years of reliable service.
Product Quality
This product has been manufactured in an ISO9001 facility and has been
calibrated during the manufacturing process to meet the stated product
specications. If a certicate of calibration is required please contact the
nearest authorized REED distributor or authorized Service Center. Please
note an additional fee for this service will apply.
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com