Full Product Manual

Automatic Data Logging Mode
In automatic mode the desired data logging sampling rate can be set
between 1 second to 8 hours, 59 minutes and 59 seconds prior to recording
(see Setting the Data Logging Sampling Rate section for details). In order to
setup the meter for automatic data logging, follow steps 1 through 5 below.
1. Press the REC button and "REC" will appear on the LCD.
2. Press the LOG button to enter automatic data logging function as
indicated by "DATALOGGER".
Note: If a card is not inserted or the card is defective, the meter will display
"EMPTY DATALOGGER". In this case, power the meter OFF and try again
with another SD memory card or verify that the card is correctly inserted.
3. The "DATALOGGER" icon will appear on the LCD and will ash every
time a reading is stored.
4. To pause the data logging session, press the LOG button and
"DATALOGGER" will stop ashing. To resume, press the LOG
button again.
5. To end the current data logging session, press and hold the REC
button for 2 seconds.
Transferring Data from the SD Memory Card to a Computer
1. While the meter is powered Off, remove the SD memory card from
the SD card slot.
2. Insert the SD memory card into the computer.
3. Open the le(s) with Excel. See sample below:
Position Date Time Ch1_Value Ch1_Unit Ch2_Value Ch2_unit
1 19-07-10 0:01:02 0.419 mS 21.7 Degree_C
2 19-07-10 0:01:04 10 mS 25 Degree_C
3 19-07-10 0:01:10 0.5 mS 21.7 Degree_C
4 19-07-10 0:01:10 0.418 mS 21.7 Degree_C
5 19-07-10 0:01:12 0.419 mS 21.7 Degree_C
6 19-07-10 0:01:14 10 mS 25 Degree_C
7 19-07-10 0:01:16 0.419 mS 21.7 Degree_C
8 19-07-10 0:01:18 0.419 mS 21.7 Degree_C
9 19-07-10 0:01:20 10 mS 25 Degree_C
10 19-07-10 0:01:22 0.419 mS 21.7 Degree_C
11 19-07-10 0:01:24 0.419 mS 21.7 Degree_C
12 19-07-10 0:01:26 0.419 mS 21.7 Degree_C
continued...
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com