Full Product Manual

Selecting the Temperature Unit of Measure (t-CF)
Follow steps 1 through 3 when "t-CF" appears on the LCD.
1. Press the
and buttons to select to select between °C and °F.
2. Press the ENTER button to conrm selection.
3. Press the SET button to save and skip to next parameter.
Note: At any time, you can press the ESC button to exit the Setup mode
and resume normal operation.
Setting CD Temperature Compensation Factor (PEr C)
This function is only for the Conductivity (TDS) mode and is intended to
adjust the probe's temperature compensation value in % per °C. Follow
steps 1 through 3 when "PEr C" appears on the LCD.
1. Press the
and buttons to select the desired temperature
compensation. The default value is 2% per °C.
2. Press the ENTER button to conrm selection.
3. Press the SET button to save and skip to next parameter.
Note: At any time, you can press the ESC button to exit the Setup mode
and resume normal operation.
ESC
Press the ESC button when "ESC" appears on the LCD to exit the Setup
mode and resume normal operation.
Verify Set Time and Date
During normal operation, press the TIME button once to display the hour,
minute, seconds. Press the button again to display the year, month and day.
Verify Sampling Rate
During normal operation, press the SAMPLING CHECK button to view the
selected sampling rate.
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com