Full Product Manual

Enabling/Disabling Auto Power Off (PoFF)
Follow steps 1 through 3 when "PoFF" appears on the LCD.
1. Press the
and buttons to select between YES (enabled) or NO
(disabled). With the Auto Power OFF feature enabled, the meter will
automatically switch OFF after 10 minutes of inactivity to preserve
battery life.
2. Press the ENTER button to conrm selection.
3. Press the SET button to save and skip to next parameter.
Note: At any time, you can press the ESC button to exit the Setup mode
and resume normal operation.
Enabling/Disabling the Beeper (bEEP)
Follow steps 1 through 3 when "bEEP" appears on the LCD.
1. Press the
and buttons to select between ON (enabled) or
OFF (disabled).
2. Press the ENTER button to conrm selection.
3. Press the SET button to save and skip to next parameter.
Note: At any time, you can press the ESC button to exit the Setup mode
and resume normal operation.
Setting Data Decimal Format (dEC)
Numeric formats vary in different countries. By default the meter is set to
bASIC mode where a decimal point is used to separate units, (i.e. 20.00).
The European format uses a comma (i.e. 20,00) to separate units. To change
this setting, follow steps 1 through 3 when "dEC" appears on the LCD.
1. Press the
and buttons to select between bASIC and Euro.
2. Press the ENTER button to conrm selection.
3. Press the SET button to save and skip to next parameter.
Note: At any time, you can press the ESC button to exit the Setup mode
and resume normal operation.
continued...
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com