Full Product Manual

Note: At any time, you can press the ESC button to exit the Setup mode
and resume normal operation. It is recommended that new SD cards
should be formatted prior to rst use. If the formatting process fails or if
no card is inserted, the meter will display:
Setting the Time and Date (dAtE)
Follow steps 1 through 4 when "dAtE" appears on the LCD.
1. Press the
and buttons to adjust the year as indicated by "YY."
2. Press the ENTER button to conrm selection.
3. Repeat steps 1 and 2 for month, day, hour, minute and seconds as
indicated by (mm/dd/h/m/s).
4. Press the SET button to save the time stamp and skip to next parameter.
Note: At any time, you can press the ESC button to exit the Setup mode
and resume normal operation. The internal clock will keep accurate time
when the meter is powered off. When new batteries are installed the clock
will have to be reset.
Setting the Data Logging Sampling Rate (SP-t)
Follow steps 1 through 4 when "SP-t" appears on the LCD.
1. The sampling rate can be set from '0' seconds (manual log mode
only) up to 8 hours, 59 minutes and 59 seconds.
2. Press the
and buttons to to adjust the required sampling rate by
hours, minutes or seconds as indicated by (h/m/s).
3. Press the ENTER button to conrm each selection.
4. Press the SET button to save the selected sampling rate and skip to
next parameter.
Note: At any time, you can press the ESC button to exit the Setup mode
and resume normal operation.
continued...
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com