Use and Care Manual

13
Audible Alarm Setting
Press the SET button ve times and the audible alarm indicator will
appear on the display. Press the UP or DOWN buttons to turn the audible
alarmOn/Off.Theinstrumentwillexitthesetupafter10secondsofinac-
tivity or if the trigger is pulled at any time.
Trigger Lock Setup
Press the SET button six times and the temperature measurement trigger
lock indicator will appear on the display. Press the UP or DOWN
buttonstoturnthetriggerlocksetupon/off.Whenthetemperature
measurement trigger lock is turned on, press the
button to enter the
timestampfunctionandthehoureldwillash.PresstheUP or DOWN
buttonstoadjustthehourvalues.Pressthe
button again to switch to
theminuteseld.Toadjust,presstheUP or DOWN buttons. Press the
a third time to conrm the entered time stamp. The instrument will exit the
setup after 10 seconds of inactivity or if the trigger is pulled at any time.
Turning High and Low Alarms ON/OFF
Press the HI/LO button to enable or disable the set alarms. To set alarms
refer to Setting the High Temperature Alarm or Setting the Low Tempera-
ture Alarm. When the high alarm limit is turned on as indicated by HI
onthedisplay,theredLEDand"HI"indicatorwillashwhentheset
temperature is exceeded. If the audible alarm function has been turned
on, the meter will also emit a beeping sound.
When the low alarm limit is turned on as indicated by LO on the display,
theblueLEDand"LO"indicatorwillashwhenthemeasuredvalueis
below the set alarm. If the audible alarm function has been turned on, the
meter will also emit a beeping sound.
continued...
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com