Use and Care Manual

12
Adjusting Emissivity
Theinstrument'semissivitycanbeadjustedfrom0.01to1.0tomeetthe
type of surface being measured. Refer to the Emissivity Chart for refer-
ence. Press the SET button three times to enter the emissivity setup. Press
the
button to toggle between emissivity preset values as indicated by
P1-P5. UsetheUP and DOWN buttons to set the emissivity values. Press
the UP and DOWNbuttonstoaddorsubtract0.01unitand/orholdthe
UP and DOWN buttons to add or subtract 0.1. The instrument will exit the
setup after 10 seconds of inactivity or if the trigger is pulled at any time.
Switching the Unit of Measure (°F/°C)
Press the SETbuttonfourtimestoenterunitofmeasuresetup.UsetheUP
and DOWNbuttonstoswitchbetween°Fand°Cunits.Theinstrumentwillexit
the setup after 10 seconds of inactivity or if the trigger is pulled at any time.
continued...
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com