Operation Manual

9
10. Identify the Left Pedal (22), which is marked
with an “L.” Using an adjustable wrench, firmly
tighten the Left Pedal counterclockwise into the
Left Crank Arm (24). Tighten the Right Pedal
(not shown) clockwise into the Right Crank Arm
(not shown). IMPORTANT: Tighten both
Pedals as firmly as possible. After using the
exercise cycle for one week, retighten the
Pedals.
Adjust the Left Pedal Strap (25) to the desired
position, and press the end of the Left Pedal
Strap onto the tab on the Left Pedal (22).
Adjust the Right Pedal Strap (not shown) in
the same way.
10
11. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
9. Push the seat handle down. Pull the Seat
Carriage (41) towards the back of the exercise
cycle until it stops. Then, pull up on the seat
h
andle to lock the Seat Carriage in place.
W
hile another person holds the Seat Bracket
(11) near the Seat Carriage (41), connect the
Right Controller Wire (82), which has a tag
attached, to the wire on the Rear Wire
Harness (51) that has a tag attached. Then,
connect the Left Controller Wire (61) to the
other wire on the Rear Wire Harness. Make
sure that the connectors on the Controller
Wires (61, 82) are positioned side by side
under the plastic cover on the Seat Bracket.
Be careful to avoid pinching and damaging
the wires. Attach the Seat Bracket (11) to the
Seat Carriage (41) with four M8 x 19mm Button
Screws (77) and four M8 Split Washers (55).
22
25
24
11
61
41
51
82
77
77
Plastic
Cover
Seat
Handle
55
55
9
A
void pinching and
damaging the wires