Operation Manual

6
2. While another person lifts the rear of the Frame
(
1), attach the Rear Stabilizer (16) to the Frame
with four M8 x 50mm Button Screws (52) and
four M8 Split Washers (55).
52
1
6
1
4
2
Avoid pinching
and damaging
the wires
1
4. While another person holds the Upright (2) near
the Frame (1), use the wire tie in the Upright to
pull the Upper and Main Wire Harnesses (42,
43) through the Upright. See the inset
drawing. Tie the wire tie to the ends of the Wire
Harnesses. Then, pull the other end of the wire
tie upward out of the top of the Upright.
Attach the Upright (2) to the Frame (1) with an
M10 x 63mm Bolt Set (62). Be careful to avoid
pinching the Wire Harnesses (42, 43).
2
52
55
55
62
43
62
42, 43
42
3
7
1
3. Tighten the Upright Knob (7) into the Frame (1).
Wire Tie