Specifications
Table Of Contents
- CONTENTS
- PRECAUTIONS
- CONTENTS CHECKLIST
- HARDWARE COMPARISON CHART
- PARTS LIST
- PARTS LIST
- PARTS LIST
- PARTS LIST
- PARTS DIAGRAM
- PARTS DIAGRAM
- PARTS DIAGRAM
- PARTS DIAGRAM
- PARTS DIAGRAM
- PARTS DIAGRAM
- PARTS DIAGRAM
- ASSEMBLY INSTRUCTIONS
- ASSEMBLY INSTRUCTIONS
- ASSEMBLY INSTRUCTIONS
- ASSEMBLY INSTRUCTIONS
- ASSEMBLY INSTRUCTIONS
- ASSEMBLY
- FOLDING INSTRUCTIONS
- UNFOLDING INSTRUCTIONS
- LEVEL ADJUSTMENT
- COMPUTER INSTRUCTIONS
- COMPUTER OPERATION
- INCLINE UP/DOWN Buttons
- COMPUTER OPERATION
- COMPUTER OPERATION
- COMPUTER OPERATION
- COMPUTER OPERATION
- HELPFUL HINTS
- STRETCHING ROUTINE
- STRETCHING ROUTINE
- TRAINING WITH REEBOK UNIVERSITY
- HOW TO MAINTAIN THE FUSION TREADMILL
- HOW TO MAINTAIN THE FUSION TREADMILL
- TROUBLESHOOTING
- ORDERING REPLACEMENT PARTS / LIMITED WARRANTY
Fusion TREADMILL
39
HOW TO MAINTAIN THE FUSION TREADMILL
Belt and Deck Lubrication
The belt and deck were pre-lubricated in the factory prior to assembly. The factory lubrication usually lasts 60-120 days
depending on the frequency of use. The FUSION TREADMILL comes with a small bottle of lubricant. This is enough to
lubricate your FUSION TREADMILL twice (4 ML). Lift the side of the belt 18 inches/45 cm from the rear roller. Squeeze 1
ML under the left side of the belt and 1 ML under the right side of the belt. Run your FUSION TREADMILL at 5 MPH/8 KMH
for 5-10 minutes before exercising. Please be aware that if you over lubricate your FUSION TREADMILL you will
INVALIDATE YOUR WARRANTY. RFE accepts no liability. The lubricant may be applied whenever sticking occurs but, we
recommend you lubricate the belt and deck every 120 days for normal use (3 days a week,
30-45 minutes per day) and every 60 days for frequent use (more than once a day, 30-45 minutes per workout).