User Manual

Operation

RUN: To run the MIDI sequencer, press the [RUN/PAUSE] button

once. The selected pattern in your MIDI sequencer should now be

playing in synchronisation with the audio input track.

PAUSE: To pause the MIDI sequencer at any time, press the

[RUN/PAUSE] button again. The MIDI sequencer's pattern or song

will be held at the pause position and will only continue from that

point if the [RUN/PAUSE] button is pressed once again.

RESET: If you want to run the MIDI pattern from the start point

again, in [PAUSE] mode press the [STOP/RESET] button

before pressing the RUN/PAUSE button again. This resets the MIDI

pattern/song to beat 1/bar1

RESET (BEAT 1/BAR 1): For details on the [RESET] function in

[PAUSE] mode please see above.

STOP: The [STOP] function is used to stop the MIDI clock

TIP! To set the initial alignment of the MIDI sequence and audio

track, press this button quite accurately on the desired beat.

NOTE! due to PC MIDI interface latency specifications you may find

there is a short delay between pressing the [RUN/PAUSE] button

and your PC sequencer actually starting the sequence playback. If

this occurs try to anticipate it by pressing [RUN] slightly earlier.

once

(Note: do not press the [STOP/RESET]

button twice as this will reset the sync position - see next page)

TIP! The SoundBITE micro will continue running the MIDI clock

output indefinitely at the last detected BPM rate if the beats in the

audio track become unavailable (vocal sections/end of track etc).

and

Any

misalignment error can easily be corrected using the [PULL] and

[PUSH] buttons - see page 20 for details

Stop/Reset Control