User Manual

To increase/decrease the volume simply use the [PULL] or [PUSH]

buttons the [LOOP] button. To exit this

mode simply release the [LOOP] button.

LOOP SYNC ADJUSTMENTS - INDIVIDUAL LOOPS: Use this

feature to adjust the synchronisation of each loop independently.

To adjust the synchronisation point of an individual loop, first press

and hold down the [LOOP] button when it is in [MUTE] mode

(button indicator OFF). To increment/decrement the loops’ sync

point simply press the [PULL] or [PUSH] buttons

the [LOOP] button. As the loop synchronisation is adjusted,

the loop playback will be automatically ‘time stretched’ (playback

speed slowed down or speeded up) whilst keeping the same pitch.

To exit this mode simply release the [LOOP] button.

You can still

record loops, even if there is no beat information available to trigger

the BPM engine. First, manually set a BPM value (see page 13),

then press the [RE-SAMPLE] button and a [LOOP] button to create

the non-synchronised loops.

MIDI sequencer to recognise e MIDI

Clock commands - please consult the sequencer manufacturers

operation manual to make the necessary settings.

Select a suitable pattern, clip or song on your MIDI sequencer.

whilst still holding down

whilst still holding

down

xternal

RECORDING LOOPS WITHOUT THE BPM ENGINE:

Ensure the [MODE] switch is set to the [MIDI] position!

Set the connected

Operation

MIDI Clock Synchronisation

Run/Pause Control ( )