User Manual

ABORTING THE LOOP RECORDING: You can abort the loop
recording process at any time during the recording phase by simply
pressing the selected [LOOP] button once again.
Now try recording some more loops using the other loop pads. A
total of four loops can be recorded and played back simultaneously
or individually muted as desired. You can even mute/play pre-
recorded loops as another loop pad is being recorded!
This is where you erase all the loops simultaneously. To erase any
recorded loops simply press the [ERASE ALL] button and hold for
approximately half a second - the tri-colour indicator will flash [RED]
rapidly several times to confirm all recorded loops have been
erased. The four loop pads are now empty and ready for the next
recording session.
This is where you re-sample (replace) existing loops individually
without erasing all the loops as detailed in the previous section. You
can also use this mode to record empty loop pads if desired. To
enter this mode press the [RE-SAMPLE] button once.
The indicators in the [LOOP] pads will now flash. Un-recorded loop
pad indicators will flash alternately to those loop pads that contain
recorded samples to identify the two different conditions.
TIP! SoundBITE micro’s memory is non-volatile so please
remember that any recorded loops could be lost if the internal
battery fully discharges before the power adapter is reconnected. In
power [SLEEP] mode, the loops should be safely retained for a
period of 8 >10 hours.
16
Operation
Erasing Loops
Re-Sampling Loops