User Manual

Operation

After connecting to your system as detailed on

page 6, insert the power adapter plug into the rear panel socket

marked [6VDC]. The internal battery will now start charging and

internal power will be switched on however,

features a special [SLEEP] mode to economise on battery life. In

[SLEEP] mode, the tri-colour indicator will flicker at low brightness.

To ‘wake-up’ simply press & hold the [BPM

ON/OFF] button for approximately 2 seconds. The tri-colour

indicator will now light [RED] to indicate power is on and the BPM

engine is idle (no beat detected). Your is now

ready to use!

When you want to conserve battery life, simply press & hold the

[BPM ON/OFF] button again for approximately 2 seconds. All the

indicators will now switch off.

SoundBITE micro

SoundBITE micro,

SoundBITE micro

TIP! You can use [SLEEP] mode to store loop samples whilst

travelling. Any loops recorded during normal operation will be stored

in memory for later use. Providing the battery is fully charged you

can store the loops for up to 10 hours.

SoundBITE micro

This is where you set the working range of the BPM engine. There

are three individual operating ranges covering a total range of 60 -

230 BPM. This allows to work with most dance

music styles, from the slowest Soul to the fastest Drum & Bass. The

default setting is 90-180BPM, which covers most dance music

requirements. To change the range setting, first the

[TAP/CLEAR] button and then press either:

[PULL] button - selects the low range (60-120BPM) or...

[PUSH] button - selects the high range (115-230BPM)

press & hold

Power On/Off

BPM Range