User guide
11
Effect of Seasonal Incoming Water
Temperature Changes
The required water temperature is achieved by
adjusting the rate of water flow.
The diagram shows the principle involved in
relating temperature rise to flow rate.
The higher the water rate
the lower the temperature
and vice versa.
The temperature of the
water supplied from the
mains can vary
considerably throughout
the year from 5 to 20°C.
This means that in the winter, flow rate will be
less than in the summer to achieve the same
outlet temperature.
In summer the ‘Economy’ (2 x red bars) power
setting may give adequate hot water.
Effect of Other Water Devices on Incoming
Water Supply
Your shower is designed to stabilise
temperature changes caused by water
pressure fluctuations.
These can result from toilets being flushed or
taps being turned on and off.
When this happens your showering temperature
will be held within a controlled band, provided
that the minimum pressure required by the
shower is maintained.
Your shower requires a minimum running
pressure of 100kPa (1.0 bar, 15 psi) at a
minimum flow rate of 8 litres/minute.
(
9 litres/minute for 9.5kW).
At pressures above 100kPa (1.0 bar, 15 psi) at a
minimum flow rate of 8 litres/minute.
(
9 litres/minute for 9.5kW),
it will minimise
temperature fluctuations as detailed above.
If the water pressure falls below 100kPa
(1.0 bar, 15 psi) at a minimum flow rate of
8 litres/minute, (
9 litres/minute for 9.5kW),
it is likely that the pressure switch will turn off
the power to the heating elements, resulting in a
cold shower.
Please Note:-
The fitting of Spare Parts must be supervised
by a suitably qualified person.
Front Cover complete Cat No. 93672121
Heat Exchanger (7.2kW) Cat No. 93672122
Heat Exchanger (8.5kW) Cat No. 93672102
Heat Exchanger Bottle Cat No. 93672114
Solenoid Valve Cat No. 93672104
Solenoid Securing Strap Cat No. 93672115
Flow Valve Top Assembly Cat No. 93672105
Tank Clip Cat No. 93672106
Pressure Relief Device Cat No. 93672107
Heat Exchanger ‘O’-Rings Cat No. 93672108
Thermal Cut-Out Cat No. 93672109
Pressure Switch Assembly Cat No. 93672110
Detachable corner Section Cat No. 93672111
Terminal Block Cat No. 93590372
Single-Mode Handset Cat No. 93590738
Chrome Shower Hose (1m) Cat No. 93672120
Height Adjuster Cat No. 93590744
Ø18mm Riser Rail Tube Cat No. 93593533
Ø18mm Riser Rail Brackets Cat No. 93795877
A number of Additional accessories and
spare parts can be supplied.
Please contact our After Sales Service
Department (see Section 5)
WRAS Water Isolating Valve Cat No. 93793757
Chrome Accessories Cat No. 83595318
Chrome Premium Accs Cat No. 83595319
Chrome Curved Accs Cat No. 83595320
Curtain and Rail Pack Cat No. 83792812










