User Manual

Redpine Signals, Inc. Page 13
R
R
S
S
-
-
W
W
C
C
-
-
3
3
0
0
1
1
E
E
v
v
a
a
l
l
u
u
a
a
t
t
i
i
o
o
n
n
B
B
o
o
a
a
r
r
d
d
U
U
s
s
e
e
r
r
G
G
u
u
i
i
d
d
e
e
V
V
e
e
r
r
s
s
i
i
o
o
n
n
2
2
.
.
5
5
1
1
Table 6: Sensor Interface Header
USB Interface
This is a USB 2.0 interface and is supported in firmware version
2.0.0.1.2.4 and above.
Jumper
The jumper shown in some versions of the EVBs can be used for
measurement of current consumed by the module.
NOTE: EVB Versions below 3.1 do not support Power Save Mode 3 (Refer to
Programming Reference Manual version 1.9 or higher for definition of this mode).
2.1 Test Setup
The following additional components (not included with the EVB) are
required to complete the procedures described here.
1. PC with an available serial port, and running Windows XP. The PC
would be interfaced to the UART port of the EVB.
2. An 802.11a, 11b, 11g, or 11n Access Point with administrative
access to change its settings
3. A RADIUS server for operation in enterprise security mode (see
section Evaluation of Client Mode with Enterprise Security for
details)
4. A Wi-Fi Direct™ compatible mobile phone or laptop (see section
Evaluation of Wi-Fi Direct Mode )
5. A third party client device, such as a laptop or Wi-Fi phone, for
evaluating the EVB in the Access Point mode.