User Manual

Redpine Signals, Inc. Page 6
Connect
-
io
-
n™
RS9110-N-11-24
Evaluation Board User Guide
V
V
e
e
r
r
s
s
i
i
o
o
n
n
3
3
.
.
1
1
3
3
1 Introduction
This document describes how to use the RS9110-N-11-24 EVB. It
describes the sequence of commands and set-up requirements to quickly
evaluate the major functions of the modules.
Chapters Using the Evaluation Board in UART mode to Evaluating the
Module in Infrastructure mode describe operation using the UART
interface. Using the Evaluation Board in SPI mode describes operation
using the SPI interface. Upgrading Firmware describes the firmware
upgrade procedure. Even if the user does not plan to use the UART
interface, it is recommended to go through the UART section because all
the set-ups to evaluate different functionalities of the module in UART
mode are directly reusable in the SPI mode also.