User Manual

Redpine Signals, Inc. Page 44
Connect
-
io
-
n™
RS9110-N-11-24
Evaluation Board User Guide
V
V
e
e
r
r
s
s
i
i
o
o
n
n
3
3
.
.
1
1
3
3
k. Source IP Address, Source Subnet Mask, Source Gateway
Address: If DHCP is disabled, an IP address, subnet mask
and gateway address should be entered for “Source IP
Address”, “Source Subnet Mask” and “Source Gateway”
respectively. The module will get configured with these
parameters.
l. Feature Bitmap- Set this field to ‘0’.
m. Auth mode- If “WEP” is selected in “Security Mode”, then
the options of “WEP Open” or “WEP Shared” should be used
here.
5. Click on the button “Set Configuration”. The configuration
information is stored in non-volatile memory of the module and
can be accessed by the Host at any time using the at+rsi_cfgget
command.
6. The GUI will send the message “Configure Success”. The module
sends the message “AT+REMOTE_CFG” to the Host
21
PC (P). Once
the message is received, the module can be power cycled or hard
reset. The module sends the message – “Firmware upgrade
(y/n)”. Send “n/n” to the module. Now issue the command
at+rsi_band to configure the correct band of operation. After this
command is issed, the module will automatically join to the
configured AP or Ad-hoc network depending on the parameters
entered in the above steps.
NOTE: When the module is configured using wireless interface, the “Auto-join”
feature is enabled. This makes the module join to the configured AP on the next
power cycle or hard reset. If at any point of time, the user wants to disable the
“Auto-join” feature, the command (at+rsi_cfgneable=0) should be used.
3.7 General Operation of the Modules
21
The message is sent in uppercase alphabets