User Manual

Redpine Signals, Inc. Page 40
Connect
-
io
-
n™
RS9110-N-11-24
Evaluation Board User Guide
V
V
e
e
r
r
s
s
i
i
o
o
n
n
3
3
.
.
1
1
3
3
“Source Subnet Mask” and “Source Gateway” respectively.
The module will get configured with these parameters.
l. Feature Bitmap- Set this field to ‘0’.
m. Auth mode- If “WEP” is selected in “Security Mode”, then the
options of “WEP Open” or “WEP Shared” should be used here.
7. Click on the button “Set Configuration”. The configuration information
is stored in non-volatile memory of the module and can be accessed
by the Host at any time using the at+rsi_cfgget command.
8. The GUI will send the message “Configure Success”. The module
sends the message “AT+REMOTE_CFG” to the Host
17
PC (P). Once the
message is received, the module can be power cycled or hard reset.
The module sends the message – “Firmware upgrade (y/n)”. Send
“n/n” to the module. Now issue the command at+rsi_band to
configure the correct band of operation. After this command is issued,
the module will automatically join to the configured AP or Ad-hoc
network depending on the parameters entered in the above steps.
3.6.1.2 Wireless Configuration When the Module is Connected to an AP
The next section describes wireless configuration when the module is already
connected to an AP.
Figure 10: Wireless Configuration Set-up
1. Assuming the module is already connected to an AP through the
normal functional flow, connect a Laptop to the same AP.
2. Open the application
RS.CN.xx.GENR.UT.x.x.x\Software\Wireless_Upgrade\
DeviceConfigGUI.jar in Laptop (C) and click on the connect button.
17
The message is sent in uppercase alphabets
PC
(P)
RS
911
0
-
N
-
11
-
24
UART
Interfac
AP
Laptop (C)