User guide

Redpine Signals, Inc. Proprietary and Confidential. Page 83
R
R
S
S
9
9
1
1
1
1
0
0
-
-
N
N
-
-
1
1
1
1
-
-
2
2
2
2
/
/
2
2
4
4
/
/
2
2
8
8
S
S
o
o
f
f
t
t
w
w
a
a
r
r
e
e
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
R
R
e
e
f
f
e
e
r
r
e
e
n
n
c
c
e
e
M
M
a
a
n
n
u
u
a
a
l
l
V
V
e
e
r
r
s
s
i
i
o
o
n
n
4
4
.
.
1
1
5
5
“Source Subnet Mask” and “Source Gateway” respectively.
The module will get configured with these parameters.
l. Feature Bitmap- The decimal value of the parameter “bitval” of
the command Feature Select can be entered here. It can be
set to „0‟ for most use cases.
m. Auth mode- If “WEP” is selected in “Security Mode”, then the
options of “WEP Open” or “WEP Shared” should be used here.
7. Click on the button “Set Configuration”. The configuration information
is stored in non-volatile memory of the module and can be accessed
by the Host at any time using the at+rsi_cfgget command.
8. The GUI will send the message “Configure Success”. The module
sends the message “AT+REMOTE_CFG” to the Host
1
PC (P). Once the
message is received, the module can be power cycled or hard reset.
The module sends the message – “Firmware upgrade (y/n)”. Send
“n/n” to the module. Now issue the command at+rsi_band to
configure the correct band of operation. After this command is issed,
the module will automatically join to the configured AP or Adhoc
network depending on the parameters entered in the above steps.
1
The message is sent in uppercase alphabets