User guide
Redpine Signals, Inc. Proprietary and Confidential. Page 197
R
R
S
S
9
9
1
1
1
1
0
0
-
-
N
N
-
-
1
1
1
1
-
-
2
2
2
2
/
/
2
2
4
4
/
/
2
2
8
8
S
S
o
o
f
f
t
t
w
w
a
a
r
r
e
e
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
R
R
e
e
f
f
e
e
r
r
e
e
n
n
c
c
e
e
M
M
a
a
n
n
u
u
a
a
l
l
V
V
e
e
r
r
s
s
i
i
o
o
n
n
4
4
.
.
1
1
5
5
3. Click on the “Get Configuration” button. It displays the currently
stored configuration parameters. These parameters can be ignored for
now.
4. Fill the values of the parameters
a. Channel: Channel number of the AP or Adhoc network that the
module should connect to. Refer tables Channel Number
Parameter (2.4 Ghz) and Channel Number Parameter (5 Ghz).
b. Network Type
c. Security Mode- Security mode of the Access Point or Adhoc
network
d. uRate (refer table Data Rate Parameter)
e. Tx Power
f. Pre shared key- This can be left unfilled if the security mode is
“Open”.
g. SSID- This is the SSID of the Access Point or Adhoc network to
which the module should join
h. IBSS mode (Adhoc)
i. uChannel
j. DHCP Enable/Disable- Used in infrastructure mode
k. Source IP Address, Source Subnet Mask, Source Gateway
Address: If DHCP is disabled, an IP address, subnet mask and
gateway address should be entered for “Source IP Address”,
“Source Subnet Mask” and “Source Gateway” respectively. The
module will get configured with these parameters.
l. Feature Bitmap- The decimal value of the parameter
feature_select_bitmap of the command Feature Select can be
entered here. It can be set to „0‟ for most use cases.
m. Auth mode- If “WEP” is selected in “Security Mode”, then the
options of “WEP Open” or “WEP Shared” should be used here.
5. Click on the button “Set Configuration”. After the configuration is
successfully stored in the module, it sends an interrupt to the Host.
The Host should read the status in the same way as 17 and should
get the read value as 0x18. The configuration information is stored in
non-volatile memory of the module and can be accessed by the Host
at any time using the command “Get Information about Stored
Configuration”.
6. The module should now be power cycled or hard reset. The “Band”
command should be issued, after which the module will automatically
connect to the configured AP.