Reference Manual

Redpine Signals, Inc. Proprietary and Confidential Page 87
RS9116 n-Link Linux and Android
Technical Reference Manual
Version 2.0
16 Compliance and Certification
M7DB6 module is FCC/IC/CE certified. This section outlines the regulatory information for the
M7DB6 module. This allows integrating the module in an end product without the need to obtain
subsequent and separate approvals from these regulatory agencies. This is valid in the case no
other intentional or un-intentional radiator components are incorporated into the product and no
change in the module circuitry. Without these certifications, an end product cannot be marketed in
the relevant regions.
RF Testing Software is provided for any end product certification requirements.
16.1 Federal Communication Commission Statement
◆ Any changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
◆ Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
16.1.1 Labeling and User Information
◆ This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
◆ RF exposure statements
1. This Transmitter must not be co‐located or operating in conjunction with any other antenna
or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body or nearby persons.