Reference Manual

Redpine Signals, Inc. Proprietary and Confidential Page 58
RS9116 n-Link Linux and Android
Technical Reference Manual
Version 2.0
5.5.1.2 Client Mode
The steps for configuring WPS in Client mode are as follows:
1. Start the driver in Client mode.
2. Start the supplicant by entering the following command.
# ./wpa_supplicant –i <vap_name> -D bsd –c <wps_conf_file> -ddddt
3. For Push Button method:
• Push the button on the Access Point
• Enter the command below for the n-Link® STA
# ./wpa_cli –i <vap_name> wps_pbc <bssid>
Note:
This is the Access Point's MAC address. If the BSSID is not known, the input parameter will be the string named "any".
• Wait for the STA to parse all the WPS Access Points.
4. For Enter PIN method,
• Click on "Generate PIN" on the Access Point. A 4/8-digit numeric WPS PIN is generated.
• Enter the command below for the n-Link® STA
# ./wpa_cli –i <vap_name> wps_pin <bssid> <wps_pin>
1. Wait for the STA to parse all the WPS Access Points.
5. For Generate PIN method,
• Enter the command below for the n-Link® STA
#. /wpa_cli –i <vap_name> wps_pin <bssid>
• This will generate an 8-digit numeric WPS PIN.
• Enter the PIN on the Access Point
• Wait for the STA to parse all the WPS Access Points.