Reference Manual

Redpine Signals, Inc. Proprietary and Confidential Page 36
RS9116 n-Link Linux and Android
Technical Reference Manual
Version 2.0
<$id> Indicates Id of Wi-Fi device. For example if rpine0 is created for module then to view Wi-Fi related statistics related
to module then Use the below command:
# cat /proc/rpine0/stats
When 2
nd
usb device is connected to same host then rpine1 will get created, In order to see the Wi-Fi related statistics
related to 2
nd
usb module use the below command:
cat /proc/rpine1/stats
This command prints statistics related to the total management packets, total data packets with respect to a given access
category sent to/from the driver, buffer full status as well as semi buffer full status, FSM states etc.
4.10.2 Disabling Driver Debug Prints
You may opt to disable the debug prints of the driver appearing on the console by using the given below command.
Ensure that the driver is installed correctly before using this command for SDIO interface.
# echo 0x0 > /proc/onebox-hal/debug_zone
For USB interface, the proc name is onebox-mobile$devnum$busnum.
# echo 0x0 > /proc/onebox-hal<$devnum$busnum>/debug_zone