Manualshelf

Reference Manual

ManualsBrandsRedpine Signals ManualsElectronicsDual Band 802.11 a/b/g/n, Bluetooth 5.0, ZigBee Module
31323334353637383940
Redpine Signals, Inc. Proprietary and Confidential Page 32
RS9116 n-Link Linux and Android
Technical Reference Manual
Version 2.0
The above command displays the scan responses and advertising information.
• Master Mode Connected State
Ensure that the remote device is in Advertise mode and then issue the command given below:
The "remote_MAC_Addr" parameter mentioned above is the MAC address of the remote device, e.g., 00:23:AC:01:02:03.
• Slave Mode Connected State
Ensure that our device is in Advertise mode and then issue the command given below:
The "device_MAC_Addr" parameter mentioned above is the MAC address of the Redpine module, e.g., 00:23:AC:01:02:03.
4.7 OneBox-Mobile in Wi-Fi + Bluetooth Classic + Bluetooth LE Coexistence Mode
This section explains about the installation of Wi-Fi +Bluetooth Classic and Bluetooth LE modes.
Please note that in case of using Coexistence mode, each protocol should be loaded individually one after the other.
• Open the common_insert.sh file present in the "release" folder.
• Ensure that the DRIVER_MODE and COEX_MODE are set as below:
- DRIVER_MODE = 1
- COEX_MODE = 14(For WLAN Access Point, BT Classic and BT LE)
- COEX_MODE = 13(For WLAN Station, BT Classic and BT LE)
1. Follow the instructions mentioned in the section Installation in Access Point Mode (with BSD interface support), in
order to install the Wi-Fi Access Point mode.
2. Run the bt_enable.sh or wlan_bt_insert.sh or onebox_insert.sh script present in the "release" folder as per the
instructions mentioned in Installation of Modules to start the Bluetooth LE mode. This script inserts Wi-Fi, Bluetooth
modules as well as common HAL modules, provided if it is not inserted initially.
3. To check whether the Bluetooth Classic and Bluetooth LE mode has been started successfully or not, run the given
below command.
If the driver has been installed successfully, the above mentioned command displays a network adapter named "hciX". An
example output is given below: