HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 848-D3Z-93A0 (005) U S OWNER'S/OPERATOR'S MANUAL HEDGE TRIMMER HTZ2460 HTZ2460L CHTZ2460 CHTZ2460L WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. WARNING Before using our products, please read this manual carefully to understand the proper use of your unit. This spark ignition system complies with the Canadian standard ICES-002.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L SAFETY FIRST Instructions contained in warnings within this manual marked with a symbol concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. ■ WARNINGS IN THE MANUAL WARNING This mark indicates instructions which must be followed in order to prevent accidents which could lead to serious bodily injury or death.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 1. Parts location U S 1. 2. 3. 4. 5. 6. 7. 8. Front handle Rear handle Ignition switch Throttle lever Safety lock Blade Gear case Spark arrester 9. 10. 11. 12. 13. 14. 15. Starter knob Primer pump Fuel tank Fuel tank cap Choke lever Air cleaner cover Spark plug cap 2. Specifications Model Type HTZ2460 HTZ2460L CHTZ2460 CHTZ2460L Reciprocating Reciprocating single-sided dual blades double-sided dual blades Dry weight 5.8(kg)/12.6(lbs) 6.4(kg)/14.1(lbs) 5.8(kg)/12.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 3. Warning labels on the machine (1) Read owner's manual before operating this machine. (2) Wear head, eye and ear protection. (3) Handling this machine improperly could result in accidents causing serious injury or death. Read this manual carefully and practice using the hedge-trimmer until you are fully acquainted with all operations and have learned to use it correctly. (4) This is extremely sharp and can easily cause cuts.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 5. For safe operation 1. THIS MACHINE CAN CAUSE SERIOUS INJURIES. Read this manual carefully until you completely understand and follow all safety and operating instructions. Also, know how to stop the machine quickly in an emergency. 2. Keep this manual handy so that you may refer to it later whenever any questions arise. Also note, if you have any questions which cannot be answered herein, contact the dealer from whom you purchased the product. 3.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 5. For safe operation care should also be taken to constantly look around or otherwise check for the presence and locations of other people working so as to maintain a distance between each person sufficient to ensure safety. 2. Check the condition of working area to avoid any accident by hitting hidden obstacles such as stumps, stones, cans, or broken glass. IMPORTANT Remove any obstacle before beginning work. 3.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 5. For safe operation 3. When replacing the cutting attachment or any other part, or when replacing the oil or any lubricant, always be sure to use only RedMax products or products which have been certified by RedMax for use with the RedMax product. 4.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 6. Fuel lines or fuel tank of the engine. FUEL WARNING • Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10 ft (3 m) away from the fueling point before starting the engine.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 6. Fuel test standard has been discontinued by API in 1995 and it no longer exists. IMPORTANT • Gasoline/Oil mixture Storage Recommendations Store your gasoline or gasoline/oil mixture in a cool dry area in a tightly sealed approved container to limit the entry of moisture and additional air (oxygen). Moisture and air cause the development of varnish and gum, making the fuel stale. Stored gasoline and gasoline/oil mixture ages and loses its octane rating and volatility.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 7. Operation ■ STARTING ENGINE pulling the rope, or remove the spark plug and dry it. WARNING ■ STOPPING ENGINE (OP3) 1. Release the throttle lever and run the engine for a half minute. 2. Shift the ignition switch to the “STOP” position. • The cutting head will start moving upon the engine starts. 1. Feed fuel into the fuel tank and tighten the cap securely. 2. Rest the unit on a flat, firm place.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 7. Operation • Do not allow anyone to stay close to the hedge-trimmer while working or while adjusting the carburetor. OP7 OP8 ■ HOW TO USE HANDLE (CHTZ2460/CHTZ2460L only) To reduce fatigue when trimming hedges, the handle can be swivelled through 90° to the left or right. (OP7, OP8). Do not press the throttle during this operation ! Proceed as follows: 1. Free the handle by pressing the locking lever; (OP7) 2.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 8. Maintenance Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-road engine repair establishment or individual.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 8. Maintenance ■ SAFETY LOCK (MA8) IMPORTANT WARNING • If waste gets stuck and causes blockage around the intake air cooling vent or between the cylinder fins, it may cause the engine to overheat, and that in turn may cause mechanical failure on the part of the hedge-trimmer. MA5 ■ BLADES Oil blades each gas tank filling (MA5). • Stop operation when the safety lock is defective. • Safety lock is the device not to accelerate the throttle lever without intention.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 8. Maintenance MA11 ■ PROCEDURES TO BE PERFORMED AFTER EVERY 100 HOURS OF USE 1. Remove the muffler, insert a screwdriver into the vent, and wipe away any carbon buildup. Wipe away any carbon buildup on the muffler exhaust vent and cylinder exhaust port at the same time. 2. Tighten all screws, bolts, and fittings. 3.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L 9. Storage 1. Oil the blade to prevent rust. 2. Empty the fuel tank and put the cap back on. 3. Remove the spark plug, pour a small amount of oil into the cylinder. 4. Rotate the crankshaft several times using the starting rope in order to distribute the oil. Put the spark plug back in. 5. Wrap the engine with a plastic sheet. 6. Store the trimmer in a dry place, preferably not in direct contact with the floor and away from heat sources. U S 10.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L FEDERAL AND CALIFORNIA EMISSIONS CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), Environment Canada and RedMax are pleased to explain the emissions control system's warranty on your 2009 and later small off-road engine. In U.S.
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regular inspection in the maintenance schedule will be warranted for a period of two years. A statement in such written instructions to the effect of "repair or replace as necessary" will not reduce the period of warranty coverage. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period.
