HBZ2610 848-L0T-93A0 (001) U S OWNER'S/OPERATOR'S MANUAL BLOWERS HBZ2610 WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. WARNING Before using our products, please read this manual carefully to understand the proper use of your unit. This spark ignition system complies with the Canadian standard ICES-002.
HBZ2610 SAFETY FIRST Instructions contained in warnings within this manual and warning seals marked with a symbol on the blower concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. Note that there may be times when warning seals peel off or become soiled and impossible to read.
HBZ2610 1. Parts location U S (1) (2) (3) (4) (5) (6) (7) (8) (9) Stop switch Throttle trigger Air inlet screen Spark plug cap Recoil starter knob Air cleaner Fuel tank Blower pipe Screw 2. Specifications ■ MODEL HBZ2610 Dimensions (L x W x H) mm (in) ···············································································327x269x360 (12.9x10.6x14.
HBZ2610 3. Warning labels on the machine (1) Read owner's manual before operating this machine. (2) Wear head, eye and ear protection. (3) Handling this machine improperly could result in accidents causing serious injury or death. Read this manual carefully and practice using the blower until you are fully acquainted with all operations and have learned to use it correctly. (4) Severing of fingers or hand by fan blade. Do not open or remove safety guards or nets while engine is running.
HBZ2610 5. For safe operation WARNING • The blower is used for blowing away leaves and other debris on the ground. When operating the blower, the operater must stand with both feet firmly on the ground. Do not operate the blower while standing on a ladder or a stand. • Under no circumstances may the design of the machine be modified without the permission of the manufacturer. Always use genuine accessories and parts.
HBZ2610 5. For safe operation WARNING 2. Never use the blower without the screen at the air intake of the blower. Before each use, check that, the screw (1) is securely tightened and is free from any damage. 3. Check the work area that the blower will be used in and remove or cover all valuables that may be damaged by the air blast or thrown debris. ■ Using the product 1. To reduce the risk of injury associated with thrown objects.
HBZ2610 5. For safe operation filters. ■ For protecting your body from vibration WARNING Prolonged use of a blower, exposing the operater to vibrations and cold may produce whitefinger disease (Raynaud's phenomenon), which symptoms are tingling and burning sensations followed by loss of color and numbness in the fingers.
HBZ2610 6. Set up F1 F2 ■ BLOWER PIPE • Align groove in blower pipe with projection on blower housing (or another blower pipe) and slide the pipe onto the blower housing (or another blower pipe). Rotate the pipe clockwise to lock it into place. ■ INSTALLING SUPPORT HANDLE • This handle is supplied with the blower. • Fit the holes of volute and handle, tighten the screws. • Be sure to tighten the screws straightly.
HBZ2610 7. Fuel lines or fuel tank of the engine. FUEL WARNING • Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10 ft (3 m) away from the fueling point before starting the engine. ■ GASOLINE REQUIREMENTS • All 2-Stroke RedMax Products are powered by RedMax Professional-Commercial Duty, Hi-Performance, Hi-RPM, Air Cooled 2-Stroke engines.
HBZ2610 7. Fuel test standard has been discontinued by API in 1995 and it no longer exists. IMPORTANT • Gasoline/Oil mixture Storage Recommendations Store your gasoline or gasoline/oil mixture in a cool dry area in a tightly sealed approved container to limit the entry of moisture and additional air (oxygen). Moisture and air cause the development of varnish and gum, making the fuel stale. Stored gasoline and gasoline/oil mixture ages and loses its octane rating and volatility.
HBZ2610 8. Operation F3 ■ STARTING ENGINE 1. Rest the unit on a flat, firm place. 2. Pump the primer until fuel flows out in the clear tube. NOTE Except for an emergency, avoid stopping the engine while pulling the throttle trigger. (1) Primer F7 F4 3. Move the choke lever upward to close the choke. (1) Choke lever (2) Close (3) Open ■ ADJUSTING IDLE SPEED 1. When the engine tends to stop frequently at an idle mode, turn the adjusting screw clockwise.
HBZ2610 9. Maintenance Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-road engine repair establishment or individual. ■ MAINTENANCE CHART system/compornent procedure fuel leaks, fuel spillage fuel tank, air filter, fuel filter wipe out inspect/clean see ■ADJUSTING IDLING SPEED (p.
HBZ2610 9. Maintenance ■ MUFFLER (1) Screw (2) Air inlet screen WARNING • Inspect periodically, the muffler for loose fasteners, any damage or corrosion. If any sign of exhaust leakage is found, do not use the blower and have it repaired immediately. • Note that failing to do so may result in the engine catching on fire. F14 ■ PROCEDURES TO BE PERFORMED AFTER EVERY 50 HOURS OF USE • Remove the muffler, insert a screwdriver into the vent, and wipe away any carbon buildup.
HBZ2610 10. Storage BEFORE STORING THE BLOWER: 1. Drain a fuel tank and push the primer bulb until it becomes empty of fuel. 2 .Remove the spark plug and drop a spoonful of 2-cycle oil into the cylider. Crank the engine several time and install the spark plug. 3. Store unit in a dry, dust free place, out of the reach of children. 11. Disposal • When disposing your machine, fuel or oil for the machine, be sure to allow your local regulations. 12.
HBZ2610 FEDERAL AND CALIFORNIA EMISSIONS CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS U S The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), Environment Canada and RedMax are pleased to explain the emissions control system's warranty on your 2009 and later small off-road engine. In U.S.
HBZ2610 warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regular inspection in the maintenance schedule will be warranted for a period of two years. A statement in such written instructions to the effect of "repair or replace as necessary" will not reduce the period of warranty coverage. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period.
