User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 98 of 152 March 2, 2011
Table 31: CLI - set (PMP-Specific Commands)
conlid <id> <lid>
Link associated with this Connection.
id - Connection ID number.
lid - Link ID number.
conpri <id> <0 - 7>
Connection default priority.
id - Connection reference ID number.
convid <id> <1 - 4095>
Set or show a Connection's VLAN ID
id - Connections reference ID number.
conviden <id> <off | on>
Enable or disable VLAN connections.
id - Connection ID number.
on - VLAN is enabled.
off - VLAN is disabled.
dlminrate <id> <1 - 54>
Link minimum downlink uncoded burst rate (Mbps). Entry values are dependent
on the channel bandwidth (chwidth). See Table 5: PTP & PMP -
Modulation/Coding for UBR.
id = Link ID number.
dlpir <id> <50 - 50000>
Connections downlink peak information rate (PIR) (Kbps).
id - Connection ID number.
dlqos <id> <1 - 53>
Connection downlink QoS setting (from AN-80i PMP configuration tool).
id - Connection ID number.
dlrate <id> <6 - 54>
Link maximum downlink uncoded burst rate.
id = Link ID number.
fastreg <off | on>
Fast registration mode.
grppir <id> <50 - 50000>
Group peak information rate (PIR) (Kbps). Applies to uplink and downlink
traffic.
id - Group ID number.
grppri <id> <0 - 7>
Group default priority.
id - Group reference ID number.
grpqos <id> <6 - 53>
Group QoS (Mbps). Applies to uplink and downlink.
id - Group reference ID number.
grprate <id> <6 - 54>
Group maximum rate (Mbps). Applies to uplink and downlink.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]