User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 97 of 152 March 2, 2011
Table 30: CLI - set (PTP-Specific Commands)
will be automatically re-enabled to allow management of the AN-80i.
flowctrl <off | on>
Enable or disable the flow control function. The Flow control feature enables the AN-80i
to request other Ethernet devices to pause transmission during busy periods.
off - Disable
on - Enable
mrate <1 - 54>
Maximum uncoded burst rate (Mbps). Maximum value is set by the options key. Entry
values are dependent on the channel bandwidth (chwidth). See Table 5: PTP &
PMP - Modulation/Coding for UBR.
pllm <off | on>
Enable or disable prioritized low latency mode;
off - Disable
on - Enable
ratedif <levels>
Enter the number of modulation levels to step down during re-transmission of errored
wireless packets.
levels - Set from 0 to 7 (recommended value = 2).
snmpversion < v2 | v3 >
Select the supported version of SNMP. Note that in all current software versions this
selection is exclusive (e.g., selecting v3 excludes support of v2).
v2 - enable SNMP v2c support. This mode supports only v2c).
v3 - Enable SNMP v3 support. This mode supports only v3).
sysmode <ptpmaster | ptpslave>
ptpmaster - This unit begins transmitting automatically; sends poll messages
to the remote unit and negotiates the wireless link.
ptpslave - This unit waits passively, monitoring the selected channel(s) until
polled by the ptpmaster, and participates in negotiating the wireless link.
Table 31: CLI - set (PMP-Specific Commands)
View and change PMP-specific parameters.
set <parameter>
bsmac <00:00:00:00:00:00 | mac_address>
If set to a non-zero value, the subscriber is allowed to connect only to this base station
with this MAC address (may use '-' or ':' for separators).
bsporten <id> <off | on>
Enable and disable sector controller Ethernet port.
id - ID of port
off - Disabled
on - Enabled
congid <id> <gid>
Group associated with this Connection.
id - Connection ID number.
gid - Group ID number.
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299