User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 96 of 152 March 2, 2011
Table 29: CLI - set (Common for PTP and PMP)
local - use local authentication.
radius - Use the RADIUS server.
x509auth <off | on>
Enable or disable authentication.
off - Allow network connections without authentication.
on - Require authentication using X.509 certificates.
Table 30: CLI - set (PTP-Specific Commands)
View and change PMP-specific parameters.
set <parameter>
atpc <off | on>
Enable or disable the ATPC function. Both units monitor Rx signal and automatically
adjust the Tx level of the transmitting system to optimize system performance.
The ATPC feature must be enabled on both ends of the link.
off - Disable
on - Enable
This mode can be changed only if allowed by the options key. If the options key
does not allow changes: 1) value is specified by the options key, 2) executing a
set command for this field will generate an error message.
dataserver
Factory test only -- do not modify this parameter.
dst <distance>
Enter the actual length of the path that the wave travels in order to establish the link.
Used only if dstmod is set to 'manual'.
distance Units (mi/km) are defined by dstmu setting.
dstmode <auto | manual>
Select the mode for setting the distance of the wireless link.
auto: Distance is calculated automatically by the AN-80i.
manual: Operator enters link distance.
dstmu <mile | km>
Select the measurement unit for the link length (dstmode).
mile - dstmode units are miles
km - dstmode units are kilometers
efw <off | on>
Enable or disable the Ethernet Follows Wireless function.
off - Disable
on - Enable
When Ethernet Follows Wireless is enabled the Ethernet port status is
controlled to reflect the status of the wireless interface. When the AN-80i
detects that the wireless interface has failed (or is manually disabled), the local
Ethernet port is immediately disabled. The Ethernet port is enabled when the
AN-80i registers on the wireless link.
efwtimeout <1-9999>
Enter the period (in seconds) the Ethernet port will remain disabled following loss of
connectivity on the wireless interface. Following this interval, the Ethernet port
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]