User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 94 of 152 March 2, 2011
Table 29: CLI - set (Common for PTP and PMP)
on - Enable
radius <ip | mode | port | retries | secret | timeout>
Configure the RADIUS server (allowed in FIPS mode).
The first parameter for all commands must
be the radius server identifier (1 or 2):
ip <1 | 2> <IP address>
IP address of RADIUS server.
1 - Primary RADIUS server.
2 - Secondary RADIUS server.
For example: Set the primary RADIUS server IP address and then set the
secondary RADIUS server IP address:
set radius ip 1 192.168.100.50
set radius ip 2 192.168.100.51
mode <1 | 2> <off | on>
Mode of RADIUS server.
off - Disable RADIUS server.
on - Enable RADIUS server.
port <1 | 2> < 1-9999 >
Listening port address on RADIUS server (default port is 1812).
retries <1 | 2> < 1-999 >
Maximum number for attempts to contact target RADIUS server.
secret <1 | 2> < text >
Password for RADIUS server. Must conform to security policy.
timeout<1 | 2> < 1- 90 >
Time to wait for response from RADIUS server (seconds).
rffreq < 3.5 - 40>
Center frequency (MHz) for the RF channel. Sites operating in close proximity should
minimize interference by using a factor of the channel size for separation. For
example, 20 MHz channels should have >20 MHz separation.
snmp < off | on>
SNMP enable setting.
off - Disable the SNMP agent.
on - Enable the SNMP agent.
snmptraplink < off | on>
SNMP trap message for each Link-up and Link-down event.
off - Disable the SNMP trap message.
on - Enable the SNMP trap message.
snmptraps < off | on>
Enable or disable sending all SNMP traps.
off - Disable all SNMP trap messages.
on - Enable all SNMP trap messages.
sntp < off | on>
SNTP enable setting.
off - Disable SNTP protocol support.
on - Enable SNTP protocol support.
sntpip <ip>
Enter the SNTP server IP address. Valid only if sntp is enabled.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]