User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 92 of 152 March 2, 2011
Table 29: CLI - set (Common for PTP and PMP)
Enable or disable the Autoscan function.
off - Disable
on - Enable
When enabled, the PTP Subscriber (system mode) AN-80i automatically scans
available channels to locate the current operating frequency of the PTP Sector
Controller system. Executing a set command this field on a PTP Sector
Controller will generate an error message.
buzzer <off | on>
Enable or disable the audible alignment buzzer.
off - Disable
on - Enable
When enabled, the rate of the tone is proportional to the receive signal strength
(faster rate = stronger signal).
chwidth <bandwidth>
Enter the channel bandwidth (enabled by options key).
bandwidth Enter bandwidth in MHz (e.g., 40).
dfsaction <none | txoff | chgfreq>
Select the mode of operation for DFS.
None (0): The DFS function is disabled.
Tx Off (1): Transmission is immediately disabled when radar signals are
detected. This action is recorded in the message log and an SNMP trap
message is sent (if SNMP enabled).
Chg Freq (2): Relocate transmission to an alternative frequency immediately
when radar signals are detected. This action is recorded in the message log
and a trap message is sent (if SNMP enabled).
encmode <0 - 4>
Set the encryption mode. The same encryption level must be selected on
communicating systems.
0 - Disable
1 - 64-bit (Redline)
2 - AES 128
3 - AES 192
4 - AES 256
ethmode <auto | 10hd | 10fd | 100 fd | 100hd>
Enter a value for the combined Ethernet speed and duplex.
auto - Auto-negotiate
10hd - 10Base-T Half Duplex
10fd - 10Base-T Full Duplex
100hd - 100Base-T Half Duplex
100fd - 100Base-T Full Duplex
fipsmode <off | on>
Enable or disable FIPS mode operation. In FIPS mode, only FIPS approved algorithms
are used for SSH, HTTPS and wireless security. Refer to page 118 for a complete
description of this feature. In FIPS mode, only FIPS approved algorithms are used for
SSH, HTTPS and wireless security.
off - Disable FIPS mode.
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299