User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 90 of 152 March 2, 2011
Table 23: CLI - new
id - Specify a unique ID for this link:
6.1.12 Ping
Use the ping command to initiate an ICMP ping command from the AN-80i.
Table 24: CLI - ping
Send an ICMP ping command. This can be used to confirm network access to FTP/TFTP
servers, syslog servers, etc.
ping <IP address> <Number of Packets>
IP address IP address of target.
Number of Packets Number of ICMP packets to send (1 to 16).
6.1.13 Reboot
Use the reboot command to reboot the AN-80i software.
Table 25: CLI - reboot
Command the AN-80i to reboot. Entering 0 (zero) cancels reboot in-progress.
reboot <seconds>
seconds Number of seconds to wait before rebooting.
6.1.14 Reset
Use the reset command to zero the AN-80i statistics or ID table.
Table 26: CLI - reset
Reset AN-80i values.
reset <stats>
Enter ID of specific
Connection, Group, or Link to be reset.
stats <id>
Reset statistics for a
Connections, Groups, and Links.
id - Specify an ID to reset statistics only for that
Connection, Group, or Link. Default
is to reset all statistics (PMP only).
6.1.15 Save
Use the save command to copy edited parameter settings into non-volatile memory.
save [option] <Enter>
Table 27: CLI - save
Copy parameters to non-volatile memory. Does not affect security settings.
save <config> <defaultconfig> <idtable> <snmp>
config
Save Ethernet, wireless, and user configuration settings.
defaultconfig
Overwrite parameters with the factory default settings. The following settings are not
affected: system name, location, details and contact, frequency list, SNMP configuration,
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]