User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 87 of 152 March 2, 2011
Table 19: CLI - get (PTP-Specific Commands)
radiotemp: Radio temperature.
rflink: Link ID.
rfstatus: Status RF transmitter.
rssimax: Maximum RSSI.
rssimean: Mean RSSI.
rssimin: Minimum RSSI.
sinadr: Ration of signal to interference + noise.
txstatus: State of the wireless interface (FIPS mode only. ). Radio is disabled on failure of
any security check (hardware, firmware, software).
Off - Wireless security has disabled the transmitter.
On - Wireless security has enabled the transmitter.
ubrate: Current UBR value.
wrxpkt: Number of wireless packets received.
wrxpktd: Number of wireless packets received that were discarded.
wrxpktr: Number of wireless packets that were retransmitted.
wsstatus: Status of the wireless security.
0 - Wireless security is disabled.
1 - Wireless security is enabled.
wtxpkt: Number of wireless packets transmitted.
wtxpktd: Number of wireless packets transmitted that were discarded.
wtxpktr: Number of wireless packets that were retransmitted.
Table 20: CLI - get (PMP-Specific Commands)
Display PMP parameters.
get <parameter>
activeids: Number of active IDs.
activel
inks: Number of the active Links.
dldpkt: Number of down
Link discarded packets.
dlrpkt: Number of down
Link Rx packets counter.
dltpkt: Down
Link Tx packets counter.
idenable: ID status.
lactive:
Link active status.
ldlblk: Down
Link total blocks counter.
ldlbr: Down
Link burst rate.
ldldblk: Down
Link discarded blocks counter.
ldllfr: Down
Link lost frames counter.
ldlrblk: Down
Link retransmitted blocks counter.
ldlrssi: Down
Link RSSI.
ldlsnr: Down
Link SINADR.
llostc:
Link lost Connection counter.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]