User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 86 of 152 March 2, 2011
6.1.7 Generate
Use the generate command to generate a DSA or RSA key for use with SSH.
Table 17: CLI - generate
Create keys of the specified type. The keys are saved in flash and runtime memory.
generate <sshkey>
The AN-80i will generate a key using its own encryption engine.
sshkey <dsa | rsa>
dsa Generate DSA key for SSH.
rsa Generate RSA key for SSH (not used in v4.00 and higher).
Note: RSA is not used for SSH connections in v4.00 and higher.
6.1.8 Get
Use the get command to view system parameters. Use the following general format to
view a parameter.
Table 18: CLI - get (Common commands for PTP and PMP)
Display PTP parameters.
get <parameter>
data
link: Status of the data Link (LED).
0 - Data
Link is not active (AN-80i can not send user data).
1 - Data
Link is active (AN-80i is able to send user traffic).
erxpkt: Number of Ethernet packets received.
erxpktd: Number of Ethernet packets received that were discarded.
ethsts: Speed and duplex settings for the Ethernet port.
etxpkt: Number of Ethernet packets transmitted.
fipsstatus: Status of FIPS parameters (FIPS mode only). Refer to page 118 for a complete
description of this feature.
mac: AN-80i MAC address.
pskey <key> Encryption key.
Enter the encryption key to be shared between the sector controller and all subscribers in
this sector. This is required only when encryption is enabled.
radiotype: Radio type.
rffreq: RF frequency setting.
rfstatus: Status RF transmitter.
swver: List the downloaded software versions.
sysuptime: Display the time since the last reboot.
txpower: Current Tx power setting.
Table 19: CLI - get (PTP-Specific Commands)
Display PTP parameters.
get <parameter>
calcdst: Calculated
Link distance between units.
linkid: ID value -- unique value generated whenever wireless Link is established.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]