User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 85 of 152 March 2, 2011
Table 14: CLI - del
mode <usr | factory | fips>
Specify the type of information to display.
usr User entered files (default if type is not specified).
factory Factory default files (requires hardware jumper selection).
fips FIPS mode files. Refer to page 118 for a complete description of this
feature.
id <id>
Remove a
Group, Connection, or Link table entry.
id Unique number for
Group, Connection, or Link.
folder <usr | factory | fips>
Remove all files from the specified table.
usr - User entered files (default).
factory - Factory use only.
fip - FIPS mode files. Refer to page 118 for a complete description of this feature.
6.1.5 Enable
Use the enable command to enable a specific ID (that was disabled). Available only with
PMP.
Table 15: CLI - enable
Enable a group, connection, or link id (PMP only).
enable <id>
Enable a specific ID.
id Unique number for group, connection, or link.
6.1.6 Freq
Use the freq command to configure frequency ranges when using autoscan or DFS.
Table 16: CLI - freq
freq <add> <clearall> <del> <print> <reload>
add
Add a frequency range (up to 32 ranges).
begin - start frequency (MHz)
end - end frequency (MHz)
clearall
Delete all entries from the frequency list.
del <idx>
Delete a frequency validation range
idx - Frequency validation range index. Use 'print' to display IDs.
print
Print the list of frequency validation ranges.
Local frequency ranges:
<index> <begin> <end>
reload
Reload the active list of frequency validation ranges.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]