User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 42 of 152 March 2, 2011
group. Subscriber #3 is a member of the Pass through group and receives traffic that
does not match the VID of the Data or Voice groups.
4.1.1 Minimum Setup Requirements
A minimum set of parameters must be configured to enable data and management traffic
on any PMP deployment:
1. Links: Links identify each subscriber in the sector (by MAC address) and set the
maximum uplink and downlink throughput (UBR) for each wireless link.
2. Groups: Groups classify and filter traffic to/from core network (sector controller
Ethernet port). A Group definition must be created for each VLAN to be forwarded
over the sector controller wireless interface. The Group also defines multicast
characteristics for traffic using this VID. A 'pass through' Group can be created to
manage traffic not matched by any VLAN Group.
3. Connections: Connections classify and filter traffic to/from the remote network
(subscriber Ethernet port). A Connection definition must be created for each VLAN to
be forwarded over the subscriber wireless interface. The Connection also defines the
unicast uplink and downlink QoS for this traffic.
Notes:
1. Redline's PMP Configuration Tool must be used to obtain accurate QoS values for
Groups and Connections.
2. Use the pass through Group to transparently pass VLAN traffic across the wireless
interface.
3. Re-map VLANs between the core network (Group VID) and the subscribers local
network (Connection VID).
4. Operation is restricted to one pass through Group on the sector controller and one
pass through Connection on each subscriber.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]