User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 39 of 152 March 2, 2011
Software Version: Select the version of system software to load when the AN-80i is
rebooted. The system holds two independent software images.
Link Length Measurement Mode: (PTP only) Select the mode for setting/measuring
the distance between this and the remote-end unit.
Auto: Distance is calculated automatically by the AN-80i.
Manual: Enter the link distance manually in the
Link Length field.
Link Length: (PTP only) Enter the actual length of the path that the radio wave travels
between the two units. The link length is used to calculate the transmission-to-response
interval and reject reflections of the transmitted signal. This setting is valid only when the
Link Length Mode is set to Manual.
Link Length Measurements Unit: (PTP only) Select the units for the Link Length field.
Mile:
Link length distance is displayed in miles.
Km:
Link length distance is displayed in kilometers.
Antenna Alignment Buzzer Enable: Check this box
to enable the antenna alignment
audible tone generator in the transceiver. The rate of the tone is proportional to the
receive signal strength (faster = stronger signal).
Radio Enable: Check this box
to enable the radio transmitter. It is not be possible to
establish a wireless link when this box is unchecked.
3.4.3 Wireless Security
Use settings on this section of the screen to configure the AN-80i wireless security.
Fig. 15: Web - PTP Wireless Configuration Screen
Encryption Type: Select an encryption type for data transmitted over the wireless
interface. If an encryption type is selected, the configuration must be made on both
communicating units before any Ethernet packets can be transferred over-the-air:
None: Encryption is disabled.*
64-bit: Redline proprietary encryption scheme. Compatible with AN-50e. The Peer
MAC setting (below) must be set to match the communicating AN-80i/AN-50e).
AES 128: Advanced Encryption Standard using 128-bit encryption.
AES 192: Advanced Encryption Standard using 192-bit encryption.
AES 256: Advanced Encryption Standard using 256-bit encryption.
Peer MAC: Use this field to identify the communicating AN-80i/AN-50e. The MAC
address of the communicating AN-80i/AN-50e must be entered at both the PTP Master
and PTP Slave when using one of the following applications:
Encryption Type is set to 64-bit (Redline proprietary encryption).
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]