User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 38 of 152 March 2, 2011
Table 5: PTP & PMP - Modulation/Coding for UBR Settings
Channel Sizes (MHz)
3.5 5 7 10 14 20 28*
40*
Modulation
Coding
Uncoded Burst Rate (Mbps)
64 QAM
3/4
9.5 13.5 19.0 27.0 38.0 54.0 76.0 108.0
64 QAM
2/3
8.4 12.0 16.8 24.0 33.5 48.0 67.0 96.0
16 QAM
3/4
6.3 9.0 12.5 18.0 25.0 36.0 50.0 72.0
16 QAM
1/2
4.3 6.0 8.5 12.0 17.0 24.0 34.0 48.0
QPSK
3/4
3.1 4.5 6.3 9.0 12.5 18.0 25.0 36.0
QPSK
1/2
2.1 3.0 4.3 6.0 8.5 12.0 17.0 24.0
BPSK
3/4
1.6 2.3 3.2 4.5 6.3 9.0 12.6 18.0
BPSK
1/2
1.0 1.5 2.0 3.0 4.0 6.0 8.0 12.0
* PTP Only
Channel Width [MHz]: Select the channel bandwidth. See Table 73: Spec. - Regional
Identification Codes on page 144 for available channel widths.
Ethernet Follows Wireless: (PTP only) Check this box
to have the AN-80i disable
and enable the Ethernet port function based on the status of the wireless interface. This
feature allows switches and routers to trigger configuration changes based on changes
to the AN-80i Ethernet port status.
Disabled (
): The AN-80i Ethernet port is always enabled.
Enabled ( ):Ethernet port is controlled based on the status of the wireless interface.
Important: The Ethernet Follows Wireless setting affects all
data and management
traffic (HTTP, TELNET, and SNMP). While activated, it is not
possible to manage the
AN-80i using the Ethernet port.
Table 6: PTP - Ethernet Follows Wireless Port Status Indication
Wireless interface Status Ethernet Port Status
Link Up Enabled
Link Down Disabled
Ethernet follows wireless timeout [sec]: (PTP only) Enter the period (in seconds) the
Ethernet port will remain disabled following loss of connectivity on the wireless interface.
Following this interval, the Ethernet port will be automatically re-enabled to allow
management of the AN-80i.
Important: When Ethernet Follows Wireless Timeout is enabled, external
switches/routers monitoring the Ethernet port must be programmed to not switch
automatically when the Ethernet port function is restored -- the wireless interface may
not
be operational.
System Mode: Set the operating mode for each AN-80i system.
PTP Master: This unit begins transmitting automatically; sends poll messages to the
remote AN-80i, and negotiates the wireless link.
PTP Slave: This unit waits passively, monitoring the selected channel(s) until polled
by the PTP Master, and participates in negotiating the wireless link.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]