User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 35 of 152 March 2, 2011
3.4.2 Wireless Configuration
Use settings on this section of the screen to configure the AN-80i wireless interface.
Fig. 14: Web - PTP Wireless Configuration Screen
RF Freq. [MHz]: Enter the center frequency for the RF channel. This setting must be
identical for both AN-80i systems operating as a wireless link. The options key controls
channel availability. See Table 73: Spec. - Regional Identification Codes on page 144 for
available channels. Use the Autoscan feature to enable use of multiple channels.
When the Auto Scan field is not
checked, the PTP Slave will only register with a PTP
Master operating at the frequency specified in the RF Freq. [MHz] field.
Important
: To minimize interference, the channel frequencies for AN-
80i links
operating in close proximity should be separated by a minimum of the channel size in
use (to avoid overlapping bands).
Auto scan: Check this box to enable the PTP Slave to automatically scan available
channels to locate and register with an AN-80i PTP Master.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]