User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 32 of 152 March 2, 2011
System Name: Enter the name for this AN-80i. The name may be up to thirty (30)
alphanumeric characters including a-z, A-Z, 0-9, dash (-), and underscore (_).
System Details: Enter additional descriptive details about this AN-80i. The system
details may be up to thirty (30) alpha-numeric characters including a-z, A-Z, 0-9, dash (-
), and underscore (_).
System Location: Enter additional descriptive details about this AN-80i. The system
location information may be up to thirty (30) alphanumeric characters including a-z, A-Z,
0-9, dash (-), and underscore (_).
Contact: Enter additional descriptive details about this AN-80i. The contact information
may be up to thirty (30) alpha-numeric characters including a-z, A-Z, 0-9, dash (-), and
underscore (_).
IP Address: Enter the IP address for this AN-80i. The IP address is routable both
through the Ethernet port and over the wireless interface.
IP Subnet Mask: Enter the IP subnet mask.
Default Gateway Address: Enter the IP address of the default gateway or router on the
Ethernet segment connected to the AN-80i Ethernet port.
Flow Control Enable: (PTP only) Check this box
to enable flow control functions
(802.3x) on the AN-80i Ethernet port. Enabling this feature allows the AN-80i to request
Ethernet devices to pause transmissions during busy periods.
Prioritized Low Latency Mode Enable: (PTP only) Check this box
to enable priority
handling of 802.1p tagged traffic. When enabled, this ensures prioritized traffic is
transmitted with the lowest achievable latency, even under conditions of high IP data
traffic loading.
Table 3: PTP - 802.1p Priority Settings
Priority Setting
Highest 6, 7
4, 5
0, 3, no tag
Lowest 1, 2
SNTP Enable: Check this box to enable the SNTP protocol support. This feature
allows AN-80i systems to time-stamp log messages using a network time server. When
enabled, you must enter the network address of the SNTP server in the SNTP Server IP
Address field.
SNTP Server IP Address: Enter the network address of the SNTP server. Valid only
when the SNTP Enable field is checked.
Polling Interval [hours]: Enter the SNTP polling interval (hours).
Time Zone (GMT) [hh:mm]: Enter the hours offset from GMT for this time zone. Valid
only when the SNTP Enable field is checked.
Syslog Enable: Check this box
to enable the Syslog protocol support. This feature
allows AN-80i log messages to be saved in a central repository. When enabled, you
must enter the network address of the Syslog server in the Syslog Server IP Address
field.
Syslog Server IP Address: Enter the network address of the Syslog server. Valid only
when the Syslog Enable field is checked.
Ethernet Mode: Select the operating mode of the Ethernet port.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]