User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 29 of 152 March 2, 2011
No - RF link has not been established with the remote-end unit.
Wireless Security: Status of the wireless security selection.
Off - No wireless security.
On - Data sent over the wireless interface is encrypted.
FIPS Mode: State of the FIPS security option. Click the status (Off/On) link to view the
status of all FIPS components. Refer to page 118 for a complete description of this
feature.
Off - FIPS mode is not active.
On - FIPS mode is active and monitoring all security issues.
Uncoded Burst Rate: The current uncoded burst rate (UBR) for the wireless link.
System Mode: Choose if this unit will operate as master or slave on the wireless link.
PTP Master: This unit transmits automatically; sending poll messages to the remote
unit and negotiating the UBR (modulation and coding) for the wireless link.
PTP Slave: This unit waits passively until polled by the PTP Master.
RF Channel Frequency: RF channel frequency in use.
Tx Power: The current transmit power level. If ATPC is enabled, this value may be
different from the Tx Power setting in the System
Configuration screen.
DFS Enabled: Indicate the state of the DFS function. See 3.4.2 Wireless Configuration
for a complete description of the DFS feature.
Disabled: The DFS function is disabled.
Enabled: DFS function is activated. See
DFS Action below.
DFS Action: The avoidance action taken when radar signals are detected. See 3.4.2
Wireless Configuration for a complete description of the DFS feature. All DFS actions
are recorded in the event log.
None: The DFS feature is disabled.
Tx Off: Transmitter was switched off for 30 minutes.
Chg Freq: Transmitter was switched to a different frequency.
Link Distance: Distance between wireless systems. This may be the calculated or user-
assigned distance (System Configuration screen).
Status Code: Code indicating the status of the AN-80i system. Status codes are specific
to PMP and PTP operation. Code '0' indicates normal operation. Refer to section 6:
Diagnostics and Troubleshooting.
Ethernet MAC Address: System hardware address (also printed on product label).
IP Address: User-assigned IP address of the AN-80i.
IP Subnet Mask: User-assigned IP subnet mask.
Default Gateway Address: User-assigned IP for the default router or gateway.
3.3.2 Ethernet LAN Statistics
Rx Packets: Total packets received on the Ethernet port.
Rx Packets: Discarded: Total valid Ethernet frames (received on the Ethernet port) that
are discarded due to lack of buffer space.
Tx Packets: Number of packets transmitted on the Ethernet port (including Ethernet frames
and error correction bytes).
3.3.3 Wireless Statistics
Link ID: A new session identifier each time the wireless link is established.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]