User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 24 of 152 March 2, 2011
3.2 PTP System Information Screen
Click General Information to view the system overview screen (read-only). See the
System
Configuration screen for information about changing these settings.
3.2.1 Dashboard
The dashboard at the top of the General Information screen displays a summary of
important operational information and status indicators.
Fig. 9: Web - PTP Dashboard Display
General
IP Address: IP address setting of this unit.
Wireless Frequency: RF channel frequency.
Time: Displays time obtained from operator's Web browser.
RSSI: Received signal strength indicator measured since the last screen refresh.
SINADR: Average signal to interference, noise, and distortion ratio.
Radio Temperature: Internal temperature of the radio.
Wireless Led Indicators
When data sent over the wireless interface is being encrypted, a key symbol is displayed
adjacent to the 'Wireless' title in the dashboard. See the Wireless Security Configuration
settings on the System Configuration screen.
Fig. 10: Web - PTP - Dashboard Display - Wireless Key Symbol
Wireless Data Link LED
This indication is valid only when the RF Link LED is on solid green.
Off: Data can not
be transmitted across the wireless interface (e.g., incorrect security
settings).
On: Data can be transmitted across the wireless interface.
Wireless RF Link LED
Off: Wireless RF link is not
established.
On: Sector controller: Wireless RF link is operational to one or more subscribers.
Subscriber: Wireless RF link to the sector controller is operational.
Wireless Signal LED
This indication is valid only when the RF Link LED is on solid green. If Adaptive
Modulation is enabled, the threshold refers to the 'minimum UBR' setting.
On: Wireless link is operating at or above the requested UBR.
Blink: Wireless link is operating below the requested UBR.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]