User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 21 of 152 March 2, 2011
2.6.2 Audible Alignment
When enabled, the audible alignment signal will sound infrequently when a low signal is
detected, and more often as the signal strength increases. The audible antenna
alignment tool provides only rough adjustment for the subscriber antennas. It is
recommended to monitor the RSSI measurements to achieve maximum signal strength
when performing fine adjustments to the subscriber antenna. See the AN-80i Installation
Guidelines for detailed instructions.
To enable or disable the audible tool through the user interface:
Web: See Antenna Alignment Buzzer Enable in Web System Configuration screen.
Telnet: See 'buzzer' in CLI 'set' commands.
2.7 Managing the AN-80i
2.7.1 Web Browser (HTTP)
On the PC, open a Web browser (Internet Explorer 6 or higher recommended) and enter
the unit IP address. For new systems, the default IP address is 192.168.25.2. The
following login dialog should be displayed:
Fig. 6: Intro - Web (Browser) Login to the AN-80i
If the IP address, username and/or password have been modified since installation,
contact the network administrator to determine the current settings. If the IP address, or
the user name and password cannot be determined. See section 7.1: Long Reset
(Recover from Lost IP or Password on page 105.
2.7.2 Telnet (CLI)
The AN-80i supports two concurrent Telnet sessions. One session has full capabilities
and the second session is read-only (e.g., monitor or show parameter settings).
To connect to the AN-80i CLI management, open a Telnet session to the IP address of
the AN-80i. On a Windows™ PC, open the Run command and type 'telnet' followed by
the IP address of the AN-80i. When the command prompt screen appears, login to the
AN-80i. The unit may now be configured using the Commands.
The AN-80i supports two concurrent Telnet sessions. One session has full capabilities
and the second session is read-only (e.g., monitor or show parameter settings).
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299