User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 19 of 152 March 2, 2011
bandwidth requests from the remote unit (PTP Slave / PMP Subscriber) to provide non
contention-based traffic with predictable transmission characteristics.
2.1 Ethernet Port
The Ethernet port is a female RJ-45 connector. The AN-80i receives DC power and
exchanges data with the indoor network through the Ethernet port. The AN-80i Ethernet
port connects to the PoE Adapter using a weatherproof CAT-5E Ethernet cable. The
maximum total length of the Ethernet cable is 91.5 m (300 ft). For example, 90 m (295 ft)
from the AN-80i to the PoE and 1.5 m (5 ft) from the PoE to the network equipment.
2.2 RF Port
The RF port is a female N-type connector. The RF port is used to send and receive RF
signals to and from the antenna. A short coaxial cable is provided to connect the
transceiver to an external antenna.
2.3 Mounting Brackets
There are three mounting brackets available for the AN-80i. The lightweight (two-point)
mounting bracket (80i-LW-MNT) provides convenient mounting of one foot flat panel
antennas. The heavy-duty (four-point) mounting bracket (80i-HD-MNT) is available for
mounting two-foot flat panel and small parabolic antennas. A simple stand-alone
mounting bracket (80i-SA-MNT) is available that is allows the use of hose clamps to
mount only the AN-80i unit (for example, a large parabolic antenna must have separate
mounting hardware).
2.4 Grounding Connection
A ground-lug is provided on the AN-80i chassis. Use this connection to terminate a
grounding wire.
2.5 Indoor PoE Power Adapter
The PoE power adapter provides power to the AN-80i and connectivity to the local
Ethernet network.
2.5.1 AC Power Adapter
The AC power adapter input is auto-sensing 110/220/240 VAC 50/60 Hz.
Fig. 3: Intro - Indoor Power-over-Ethernet (PoE) Module - AC Model
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]