User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 141 of 152 March 2, 2011
9.4.2 5.4 GHz Radio: FCC & IC Antennas
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 22 dBi.
Table 68: Spec. - FCC & IC Certified Antennas: 5.47-5.725 GHz Operation
Redline Order # Gain
(dBi)
Description Tx Power
Setting (dBm)
(Part Number)
10 MHz
20 MHz
40 MHz
A12015EAS
(48-00065-00)
15
120°, 4.9-5.9 GHz, sector flat panel
7
7
7
A2209MTFW
(48-00071-00)
22
9°, 4.9-5.875 GHz, sector, flat panel
7
7
7
A36009MMO
(48-00048-01)
9
360°, 5.0 - 6.0 GHz, omni directional
7
7
7
A6017EAS
(48-00067-00)
17.5 62°, 4.9-5.9 GHz, sector flat panel
7 7 7
A9016EAS
(48-00066-00)
16.6
90°, 4.9-5.9 GHz, sector flat panel
7
7
7
Antennas not included in this list or having a gain greater than 22 dBi are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms. The RF
output power and selection must be professionally programmed and the equipment must
be installed by the manufacturer or a trained professional installer.
9.4.3 5.25 - 5.35 GHz Radio: FCC & IC Antennas
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 22 dBi.
Table 69: Spec. - FCC & IC Antennas: 5.25 - 5.35 GHz Operation
Redline Order #
(Part Number)
Gain
(dBi)
Description App. Tx Power Setting (dBm)
Channel Size
10 MHz 20 MHz 40 MHz
A12015EAS
(48-00065-00)
15 120 deg., .9-5.9 GHz,
sector flat panel
PMP 10 12 13
A2209MTFW
(48-00071-00)
22 9°, 4.9-5.875 GHz, sector, flat
panel
PTP 7 7 7
A36009MMO
(48-00048-01)
9 360°, 5.0 - 6.0 GHz, omni
directional
PMP 10 12 13
A6017EAS
(48-00067-00)
17.5 62 deg., 4.9-5.9 GHz,
sector flat panel
PMP 10 12 12
A9016EAS
(48-00066-00)
16.6 90 deg., 4.9-5.9 GHz,
sector flat panel
PMP 10 12 13
* FCC regulations require the DFS function be permanently enabled at the factory and can not be disabled
by the installer/end-user when operating in the 5.25-5.35 GHz range.
Antennas not included in this list or having a gain greater than 22 dBi are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms. The RF
output power and selection must be professionally programmed and the equipment must
be installed by the manufacturer or a trained professional installer.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]