User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 14 of 152 March 2, 2011
1.1.4 Service & Warranty Information
1. Refer all repairs to qualified service personnel. Do not remove the covers or modify
any part of this device, as this action will void the warranty.
2. Locate the serial numbers and record these on your registration card for future
reference. Use the space below to affix serial number stickers. Also, record the MAC
address identified on the unit product label.
3. Redline does not endorse or support the use of outdoor cable assemblies: i) not
supplied by Redline, ii) third-party products that do not meet Redline's cable and
connector assembly specifications, or iii) cables not installed and weatherproofed as
specified in the Installation Guidelines manual (70-00073-01-XX). Refer to the
Redline Limited Standard Warranty and RedCare service agreements.
1.2 Regulatory Notices
1.2.1 Deployment in the USA and Canada
FCC & IC Notices
1. The Model AN-80i and its antenna must be professionally installed.
2.
WARNING -- FCC & IC RF Exposure Warnings
To satisfy FCC and IC RF exposure requirements for RF transmitting devices, the
following distances should be maintained between the antenna of this device and
persons during device operation:
Table 1: FCC & IC RF Recommended Safe Separation Distances
Frequency (GHz) Mode Separation Distance
3.3 - 3.8 PTP / PMP 130 cm (52 in) or more
4.9 - 5.3 PTP / PMP 255 cm (101 in) or more
5.4 PTP / PMP 40 cm (16 in) or more
5.8 PMP 20 cm (8 in) or more
PTP 310 cm (122 in) or more
To ensure compliance, operation at closer than these distances is not
recommended. The antenna used for this transmitter must not be collocated in
conjunction with any other antenna or transmitter.
3. High power radars are allocated as primary users (meaning they have priority) of
5.250-5.350 MHz and 5.650-5.850 GHz and these radars could cause interference
and/or damage to LE-LAN devices.
4. FCC Information to Users @ FCC 15.105:
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Where DFS is required by regional regulations, this function is permanently enabled
at the factory and can not be disabled by the installer or end-user.
5. FCC Information to Users @ FCC 15.21:
Warning: Changes or modifications not expressly approved by Redline
Communications could void the user‟s authority to operate the equipment.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]