User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 126 of 152 March 2, 2011
SNMP: Off (or v3)
Telnet: Off
SSH: On
3. Enable FIPS Bypass Mode
FIPS mode can be enabled after all user accounts have been made compliant to the
FIPS security policy, and management access has been restricted to SSH.
Web: Configuration screen -> Wireless Security Configuration:
FIPS Mode Enable
CLI: set fipsmode on
Save the configuration to activate changes. If all conditions for FIPS mode are satisfied,
the AN-80i will reboot and enter FIPS mode.
Using SSH to Troubleshoot FIPS Mode
If FIPS mode does not become active, use the Command 'get fipsstatus' to show a
report of the FIPS components. The following example indicates that the user accounts
do not comply with the FIPS security policy.
Example
Check the status of FIPS mode components.
192.168.25.2# get fipsstatus
FIPS Status : OFF
FIPS Components:
FIPS Mode : OFF
Self Test : PASS
Users Validation : FAIL
HTTP : OFF (OFF)
SNMP : V3 (OFF or V3)
Telnet : OFF (OFF)
HTTPS : OFF
SSH : ON
Using HTTP to Troubleshoot FIPS Mode
If the AN-80i does not enable FIPS mode as requested, re-enable HTTP, login to the
Web GUI and click System Status in the main menu. Locate FIPS Mode and then click
on the status 'Off' link to display the FIPS Status screen. The following screens display
Fig. 53: Security - System Status - FIPS Status Off
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]