User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 102 of 152 March 2, 2011
Table 35: CLI - snmptrap
Create a new SNMP trap. The index value is assigned automatically. Up to eight settings
may be entered.
ipaddr Enter destination IP address
port Enter destination port address.
identity v2: Enter associated SNMP community string.
v3: Enter account username for authorization.
change <idx> [-p <port>] [-i <ip_add>] [-c <community>] [-u username]
Modify the specified SNMP setting.
idx Index of the SNMP trap (use 'print' command to display ids).
-i <ip_add>] Enter destination IP address.
-p <port>] Enter destination port address.
-c <community> Enter associated SNMP community string (SNMP V1 or V2).
-u <username> Enter account username for authorization (SNMP V3 only).
clearall
Delete all SNMP parameters.
del <idx>
Delete the specified SNMP trap.
idx Index of the SNMP trap to be deleted (use 'print' command to display ids).
Linkupdown
Trap indicates when the wireless
Link is lost and recovered.
Off -
On -
print
List all SNMP trap settings.
6.1.21 Test
Use the test command to load the current edited (but not permanently saved)
configuration settings. The AN-80i will operate with these settings for a period of five
minutes. During the 'test' period, you may click the Save button at any time to save this
configuration permanently (also terminating the five minute timer). If the Save button is
not
selected, the previous saved settings are reloaded.
Table 36: CLI - test
Load the current edited configuration settings (for five minutes).
test <config>
Test AN-80i configuration settings
config - Load and test configuration settings
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]